M300RJ Intelli Addressable Relay Module

The M300RJ Addressable Relay Module provides the system with a dry-contact output for activating a variety of auxiliary devices, such as fans, dampers, control equipment, etc. Addressability allows the dry contact to be activated, either manually or through panel programming, on a select basis. M300RJ(A) uses one of 159 possible module addresses on a SLC loop (99 on CLIP loops). It responds to regular polls from the control panel and reports its type and status, including the open/normal/short status of its Notification Appliance Circuit (NAC).

• Built-in type identification automatically identifies these devices to the control panel
• Integral LED “blinks” green each time a communication is received from the control panel and turns on in steady red when activated
• LED blink may be deselected globally (affects all devices)
• High noise immunity (EMF/RFI)
• The M300CJ(A) may be used to switch 24-volt NAC power, audio (up to 70.7 Vrms)
• Wide viewing angle of LED
• SEMS screws with clamping plates for wiring ease
• Direct-dial entry of address 01– 159 for Flash Scan loops, 01 – 99 for CLIP mode loops

• UL: S1570
• ULC: S1570 (A version only)
• FM Approved
• CSFM: 7300-0554:131
• MEA: 130-00-E
• FDNY: COA #6036