IP 67 SenTRI Manual Call Points are addressable call points as fire alarm system with a response time of less than 3 seconds.
Indoor/Waterproof Call Point Accessories are composed of flexible actuating elements, resettable elements and plastic membranes.
Key Switch is single pole switch having 240VAC and 2A, Voltage and current rating respectively. It has 87 x87x 52mm dimension and it is made up of ABS material.
Addressable Waterproof Call Points are available with or without an integral isolator and are designed to provide a manual alarm interface to Notifier fire alarm control panels.
The M700KACI-FG with integral isolator, is a call point designed to provide a manual alarm interface to Notifier’s fire alarm control panel.
The MCP1A product version of Indoor Callpoint is supplied with both a resistor and normally open clean contact electrical options.
The MCP5A product has the Advanced Protocol embedded. A version of this call point with built in isolation is also available.
Manual Call Points from SMS are both with a 470 Ohm resistor and Normally Open contact, complete with glass. Available in semi-flush mounting or surface mounting options to offer a manual alarm interface to non addressable fire alarm control panels.
The Manual Call Points by GENT, Honeywell are for the Vigilon and Nano system that are easy to install and enables personnel to raise an alarm in the event of a fire incident.
Every Manual Call Points With Resettable Elements are continuously monitored ensuring that the triggers are responded to in less than one second system wide.
The NRX-WCP radio alarm signalling button is a battery powered radio-frequency device, designed to be used with the NRXI-GATE radio gateway. NRX-WCP is a manual radio alarm signalling point with IP67 degree of protection.
The R5A-RF radio call point is a battery operated RF device designed for use with the M200G-RF radio gateway, running on an addressable fire system. It is a waterproof manual call point, combined with a wireless RF transceiver.
S4-34807 Keyswitch MCP
SenTRI manual call points are used for analogue addressable fire systems, manual call points are designed with a response time of less than 3 seconds.
SenTRI surface mounted key switch manual call points are used for analogue addressable fire systems, manual call points are designed with a response time of less than 3 seconds.
The Sentri by Honeywell brings a range of fully equipted equipted manual call points with resetable elements that sets an alarm during a fire emergency and can be reset again.
WCP1A Outdoor Call Point range gives you installation efficiency, flexibility and full compliance with the latest standards. The WCP1A series is supplied with both a resistor and normally open clean contact electrical options.
WCP5A Outdoor Call Point range gives you installation efficiency, flexibility and full compliance with the latest standards. The WCP5A series is supplied with both a resistor and normally open clean contact electrical options.
Gent hybrid wireless system connects to the wireless transceiver via a wireless base. The wireless base can be fitted with either a red or white interface plate.
Start your search with category name, product name, part number, etc.
Copyright © 2022 Honeywell International Inc.