Search Results

• How do I change the Event codes in the panel?
• Can I change an event code from the panel?
• Can I change an event code through the software?
• Can I change how alarms are reported to Central Station?
• Can I change how supervisories are reported to Central Station?
• Can I change how troubles are reported to Central Station?
• Can I change a Contact ID code?

• How to Troubleshoot Ground Faults?
• NAC fault and a NAC trouble lightning up
• My panel reports an internal ground fault
• My panel has a ground fault at the internal power supply

• How to Set Panel ID.
• How to Address a Panel.
• How can I set a Panel ID for a Network?
• How can I change the panel ID?

• When installing SKSS-2 / 5650, the screen displays that it has been installed, but the software states that my key is missing.
• Installing SKSS-2 / 5650 results in a blue screen. Software installs, but I can't open it.
• My computer can't recognize my license, as the driver is missing.

How to map after converting on SKSS Importer?

How will zones show on HFSS?

Where do I map my devices on SKSS?

What 2-wire smoke detectors are compatible with my Silent Knight / Farenhyt Series addressable FACP?

What 4-wire smoke detectors are compatible with my Silent Knight / Farenhyt Series addressable FACP?

What Notification Appliances are compatible with my Silent Knight / Farenhyt Series addressable FACP?

What Solenoids are compatible with my Silent Knight / Farenhyt Series addressable FACP?

What Door Holders are compatible with my Silent Knight / Farenhyt Series addressable FACP?

What non-addressable Relays are compatible with my Silent Knight / Farenhyt Series addressable FACP?

• I am getting an AC Power Loss trouble on my panel, what does this mean?
• How can I clear an AC Power Loss trouble?

• I have installed an Annunciator on my Silent Knight/Farenhyt panel, but the annunciator only displays "Key Bus Trouble".
• Upon powering up, the panel states 'Key bus trouble' even without anything wired up to it.
• After sending a configuration from HFSS the panel shows "Keybus trouble".
• After sending a configuration from HFSS the panel shows "Please wait...".

• What do I need to set up an EVAC system on my panel?
• What do I need to enable the EVS / ECS portion of my panel?
• How do I get audio from my panel?

• I am getting an Receiver 1 Trouble on my 6000 Series Silent Knight Panel, what does this mean?
• I am getting an Receiver 2 Trouble on my 2nd Gen Farenhyt Panel, what does this mean?