Rechargeable Batteries are maintenance-free, sealed electrolyte batteries & They are relatively position-independent (should not be charged upside-down), deep-cycled, cycle-resistant and long-lasting (4 to 5 years).
VARIODYN® D1 Power Amplifiers are required for the voice alarm system in class D technology with four independent power channels and galvanic isolated 100 V direct outputs, symmetric inputs, inrush current limitation and soft start.
ABS elbows and brackets for aspirating smoke detectors
ABS Rohre mit einer Lieferlänge von 3m und einem Außendurchmesser von 25mm
Accessories are designed exclusively for IQ8Quad Series Detectors.
Adapter for pole 769813
Adapter modules to connect the fire brigade peripherals (FBF, FAT, FIBS) to Esser FACP with redundant transmission paths or to expand functions.
The MCP Electronic Module is an addressable electronic module which comes with a zone isolator.
Adhesive Labels are used for DCS and DCSF series paging stations with "Honeywell" inscription.
Alarm transponder for VARIODYN D1 provides each 2 supervised relay outputs for optical alarm signaling devices to provide alarms to people.
Amplifiers Output Cables DOM
Mounting Clips are accessories designed for Aspiration Smoke System.
Backup cable RC 22 VARIODYN D1
Backup cable RC 44 VARIODYN D1, 1,2 m
CO capsule for multi-stimulus detector tester 805551
CO test gas for smoke detector tester 805582
Cable set for internal housing connections of the batteries to the amplifiers
Cables for Cabinet Rear Panel are used for prefabricated cabling of the 100 V outputs of DOM4-8 and DOM4-24, 1 and 4 piece can be connected respectively.
Threaded cable connection for housing Part No. 764752.
Accessories for easier installation of the LRMX linear smoke detector and reflectors on walls, girders, ceilings and beams.
Ceiling Loudspeaker is a cost-competitive ceiling loudspeaker which has an excellent audio performance and aesthetic appealing enclosure. This full range loudspeaker features a high sound pressure level and a wide frequency response range.
Certification set is introduced for FlexES rack assembly.
Connection board 4 IN - 2 OUT
Contact Interface Module CIM
Conventional MCP Electronic Modules are designed for FACP 80 Control Panels.
D1 PAMMI Plus Redundant Selector Switch
DC-DC converters provide a stable output voltage, e.g. to supply special detectors with stable energy in accordance with the standards.
DCSF Enclosure is a wall enclosure manufactured out of sheet steel for the inclusion a firefighter paging microphone DCSF12 or DCSF 1
The DX Connexion is an enhancement of the Morley-IAS Dimension panel range. The DX Connexion Panel series also include the modular unit PCB and Base Card.
DXc 2 loop base card - Morley Protocol
Desk Station with DGM1 Pre-Chime System in an elegant housing with 1 labelable key with LED display for key control and busy / operating / gong display and Cardioid gooseneck microphone in electret condenser technology.
Desktop call station with chime-system DIGI M4 placed in housing. 4 writable buttons with LED indicator for keyboard control.
The ES Detect automatic detector is an intelligent nonaddressable detector specifically designed for operation on conventional detector groups
Digital Call Station DCS2 redundant
Digital Key Module DKM18 for redundant call stations
Release button for hold-open system in surface-mounted and flush-mounted versions
Haftmagnets are optionally suitable for floor, ceiling and wall mounting.
Dummy plate is used to install fire stations DCSF12 or DCSF1 in the upright cabinets
Dummy plate 1 HU
ECO1003 optical smoke sensors use state-of-the-art optical chambers combined with application-specific integrated circuits (ASIC) to provide quick and accurate detection of fires.
Terminating device for the monitoring of standard-inputs when using esserbus transponders
The ESS-2Plus fire alarm control Panel can support an unlimited number of manual call points and a limited number of detectors by zone according to the limits of design and installation standards that are applicable.
End-of-line module for the end of the VARIODYN D1 voice alarm system loudspeaker line for standard compliant monitoring, when more than 20 loudspeakers are connected to a line. The module is connected to the final loudspeaker at the end of the line.
End-of-Line module EOL
For the serial essernet interface for a length up to 1,000 m.
Esserbus transponder is a refurbishment zone transponder for the fire alarm system 8000, IQ8Control and FlexES Control FACPs. Transponder generates 24V DC detector zone voltage inside the module.
Ethernet Touch Call Station
FACP Software 8000M for card 772424/772428.
Pluggable Fiber Optic module for the fiber optic switch 583394.11 in 1310 nm multimode. This provide a Fiber Optic cable length up to 2 km.
Field Bus Interface Plus is used for interfacing for the programming of the FACP 8007, 8000 C/M, 8008, gateway, ABIGA and Extinguishing Control Panels 8010 or for the direct field-side connection of a single installed loop.
Fire Brigade Control panel according to DIN 14661 exclusively for the serial connection to the fire brigade display panel FAT 4000 via SPI interface
Microprocessor-controlled fire brigade display panel acts as an additional display device for a FlexES fire alarm control panel. Serial connection to the fire alarm control panel is via RS485 interface.
UniVario Flame Detectors are used for the recognition of fast developing fires with flame formation. The three-channel IR flame detector achieves a high level of resistance towards disturbance variables via three-channel infrared evaluation.
FlexES control panels printers are parallel recording devices mounted as a table printer or, depending on the wall-mounting bracket, on the wall, next to the FACP.
Power Amplifier 4 X 250W, included battery charger
HMI Control Card FACP 8000 / IQ 8 Control With Switch-mate.
L-VHP15A/EN is a high-performance 15W voice alarm horn loudspeaker.
Housing Glass Pane is a surface mounted cabinet. These housing is MCP housing Alu glass pane.
Housing for Ex barrier
IP 54 Kit for Large MCP Cables entries to increase protection class from IP 43 to IP 54 for manual call points in die-cast aluminum housings.
IQ8Quad IP42 Protections provides protection to the IQ8Quad detector base against dust and humidity.
Variodyn D1 Input Cabling
For the serial essernet interface for a length up to 15 m.
Intevio extension keypads are for use with remote call stations. Models available with four function buttons/LED indicators, and eight function buttons/LED indicators.
Isolation and assembly base for safety Ex barrier
The flame detectors are suitable for the detection of smokeless liquid and gas fires as well as for smoke-intensive open fires in explosion-protected areas
Keyboard Cover for DCS VARIODYN D1 call station is a transparent key cap to protect from accidental key presses. So, pressing the keys is only made possible with an open cap.
LED Indicator Panel with 32 LEDs for operation as a remote indicating panel for up to 32 alarm, fault or common indicators. With integrated buzzer, buzzer off and lamp test button.
Linear Smoke Detector LRMX with a flame resistant ABS plastic housing consists of detector, operating and control unit. The LRMX has a range of 40 m using one single reflector.
Loop Isolator Module LIM
Housings are neutral and designed exclusively for Manual Call Points.
Aluminium Housing for Manual Call Point are available in different colour as well as with or without print.
Protective housing with protruding roof edge by Esser is for all Part No. 7047xx and 7048xx detector housings. It gives an increased mechanical protection as well as protection from bad weather conditions.
Mains Switching Unit MSU
VESDA-E VEA Microbore Tube Cutter are used for cutting microbore tubes.
System-tested sensing microphone for automatic volume control (AVC) of the VARIODYN D1 system. The microphones are installed in the affected area and connected via the XLR socket to the appropriate DOM input.
The mounting adapter is used for quick and secure attachment of bases of the IQ8Quad detector series, 9x00, IQ8Alarm Plus and alarm signaling devices, parallel detector indicators, etc. to suspended ceiling systems.
Mounting bracket for lintel installation
Mounting kit for ALR microphone Part No. 581316.
Out of order sign, multilingual 7047xx, 7048xx and 70490x
Output Cable DOM-AMP are used for prefabricated cabling to connect amplifier channel to each loudspeaker line in 1/18, 1/24 and 2/12. Backup Cable RC 41 VARIODYN D1 are used for 3:1 average in conjunction with 4-channel amplifier 4XD125B or 4XD250B.
Overvoltage Protection for UIM Contacts which has 48 contact inputs or outputs. These inputs and outputs are divided into 4 blocks, each with 12 pieces
Esser’s PAMMI Plus Light Software is a combination of the Pammi Plus Server and the Pammi Plus Client that allows you to have all the functions of the Pammi Plus management system on a single management station.
PAMMI Plus Server application realizes system control and communication with the components of the VARIOIDYN D1 voice alarm system and the PAMMI Plus client via Ethernet.
Peripheral clip for top hat rail is used to connect peripheral components, such as for example analog microphones, to the VARIODYN D1.
Pipe (ABS), diameter 25 mm
Honeywell provides power supplies for fiber optics which are used in non-security applications.
Power supply for telephone interface Doormaster 586116
Protective Cover for Manual Call Points is Protective housing with protruding roof edge, for all detector housing for increased mechanical protection as well as for protection from bad weather conditions.
ProxKey III™ key fobs come non-programmed or programmed with a 26- or 34-bit format.
RK-MCU INTEVIO master control units are the central management device of the INTEVIO PA/VA system, which is used to manage and monitor all devices and perform various operations.
RK-MIC remote call stations are used to perform various broadcasts and live announcement in zones.
Rack mounting Heavy Duty Drawer with PSU
Esser-eff alarm is a hold-open systems for fire barriers consist of a release device and a hold-open device. Hold-open systems are used to delimit buildings and objects in closed fire compartments to protect people and property.
The visual action indicator is used for the rapid localization of detectors in alarm in inaccessible places (ventilation, false floors, false ceilings, attics, etc.).
Repeater panel without front door as additional display for the fire alarm system
Signal/Control/CAT5 Patch Cables are prefabricated cabling from 12 control contacts of the UIM to the cabinet rear panel. Cable set are used for connecting batteries to the emergency power supply. Up to 4 pieces connectable are used per UIM.
Smoke detector tester
Spare Glass Panes are printed with red circle segments (similar to RAL 3000) for all Part No. 7047xx and Part No. 7048xx manual call points (large design).
System Communication Unit SCU
TWI-RS232 adaptor serves for implementing of the TWI bus on RS232. Use for special servicing and connecting an external system (e.g., a FACP IQ8Control or FlexES Control).The TWI-RS232 adapter is connected directly to the DOM.
Test gas for smoke detector tester 805582
Test head for heat detector together with battery & charger
Top Hat Rail is available in 400mm.
Flush mount box for DIGISystem desktop call stations with a lockable 9-pin Sub-D socket connector including an EMI/RFI filter.
Unidirectional Projection Loudspeaker by Honeywell it can be used in indoor, outdoor, dry, or wet applications, providing reliable operations over wide temperature and humidity ranges.
VARIODYN D1 Comprio 4-8 net (with Ethernet)
VSP-972 filters are spare filters for use with VEA aspirating smoke detectors.
VESDA capillary pipes and fittings are produced in red ABS under a stringent quality control system.
VESDA VLI Smoke Detectors by Xtralis is first early warning aspirating smoke detection (ASD) system, designed to protect industrial applications and harsh environments, combining a fail-safe Intelligent Filter with an advanced clean-air barrier .
VESDA® VLI early warning aspirating smoke detection systems are designed to protect industrial applications and harsh environments up to 21,520 ft2.
Ventilation panel 1 HU (without branding)
Honeywell brings Venturi Air Duct Modules for usage of the OTblue-LKM multisensor detectors- IQ8Quad. The Venturi tube dips into the airflow of the system and conducts the air into the detection chamber and back and into the air duct system.
Flush Mounted Volume Controllers are regulators for 5/30/60W power for 100V lines with 24V shunt relay.
Wall-surface mount terminal box for DCS
Z-System Zener Barrier for AV device (Drives one sounder or 2 strobes)
Zone Expander RK-ZONE8
Start your search with category name, product name, part number, etc.
Copyright © 2023 Honeywell International Inc.