For the serial essernet interface for a length up to 15 m.

Honeywell Bluetooth Dongles are elegant Bluetooth Low Energy (BLE) product by Honeywell that are used for seamless interface with the Morley DXc Panel.

M200E-DIN provides a DIN rail mounting option for one module of addressable Honeywell Morley-IAS and Notifier series modules.

Honeywell Loop Driver Card is used for Apollo XP95 or Discovery protocol.

FMM-4-20 Analog Input Module allows the NFS2-3030 fire alarm control panel (FACP) to monitor industry-standard, linear-scale, 4–20 mA protocol sensors.

The Dual Loop Interface Board is an intelligent fire alarm panel offers a technically sophisticated range of facilities and functions whilst remaining easy to install, program and operate.

Radio Input-Output Modules are battery operated RF devices designed for use with the radio gateway, running on an addressable fire system using a compatible proprietary communication protocol.

The FCM-1-REL Releasing Control Modules are specifically designed for fire suppression releasing applications in FlashScan® systems. Power to the release agent solenoid(s) runs through the module for full-time monitoring and supervision.

The new family of input/output modules form part of Honeywell TC800 Series family. Single and multi-way models are available within the same mechanical package, reducing both the cost of installation and the mounting space required.

FTM-1(A) fire phone control modules with FlashScan® mode only are intended for use with NFS-640, NFS2-640, NFS-3030, and NFS2-3030 control panels. They provide the capability to monitor and control a circuit with up to two firefighter phones.

The System Sensor M500X Fault Isolator modules enable part of the communications signaling line circuit to continue operating when a short circuit occurs. The Module is an automatic switch that opens when the line voltage drops below four volts.

FlashScan® dual relay/monitor modules are designed for use with NOTIFIER ONYX® and CLIP Series fire alarm control panels. Each relay output is intended for Form C switching applications, which do not require wiring supervision for the load circuit.