Wall and floor swivel brackets are specially intended for use with 960119 and 960120 door magnet and thus allows floor or wall installation by means of distance pipe.

Replacement Paper Roll

The N-6000P controller integrates alarm and linkage control, and is suitable for medium and small customer groups, such as budget hotels, shopping malls, residences and other places.

Door magnet comes with a distance pipe including flexible anchor

Protective Cover for Manual Call Points is Protective housing with protruding roof edge, for all detector housing for increased mechanical protection as well as for protection from bad weather conditions.

The ECO1005 A detector is a rate of rise sensor, which uses a state of the art thermal element combined with an application specific integrated circuit (ASIC)to provide quick and accurate detection of fires.

8-fuse-card

M200E-DIN provides a DIN rail mounting option for one module of addressable Honeywell Morley-IAS and Notifier series modules.

Tubing Polypropylene 1/4" O.D x 3/16" ID for exhaust , price per foot.

MCP3A Indoor Call Point range gives you installation efficiency, flexibility and full compliance with the latest standards.

Optical flame detector sensitive to infrared radiation. Equipped with relay output, which will be activated after a continuous signal of 1-10 seconds (adjustable). The detector is equipped with automatic or manual test device.

Rundum-Signalleuchten inkl. Wandhalterung. Lebensdauer LED mindestens 50.000 h. Verfügbar in den Farben gelb, rot und grün. Rotationsfrequenz 180 U/min, Spannungsbereich von 12 bis 24V DC AC/DC, IP66.

Recessed Mounting Kits by System Sensor are provides simple installation solution where the application demands a lower profile sensor.

Ex signaling device DS10, 12 V DC

VESDA-E VEA microbore tubes are custom made, high quality plenum rated flame retardant polyethylene tubes. They have superior stress crack resistance for reliable long-term performance

CO test gas for smoke detector tester 805582

Galvanic Isolators are single channel isolated repeater. They are suitable for use as an intrinsically safe isolator between an IMX-1E translator module and up to a maximum of 15 x IDX-751 AE intrinsically safe photoelectric smoke sensors.

Zone Interface Monitor Modules are intended for use in intelligent systems, where the individual address of each module is selected using built-in rotary switches. This module allows intelligent panels to interface and monitor smoke detectors.

The ECO 1000 deep detector bases are used in the ECO1000 series conventional detectors with conventional fire alarm control panels.

Replacement dust covers are for use with System Sensor® 100/200 Series smoke detectors.

SOLO Mains Heat Tester has a voltage rating of 220V-240V. Compatible to SOLO 814 model.

Internal filter for FAAST systems. Price Pack of 2 pieces. Sold in multiples of 2

Surface mount deep base in pure white

CM4 Toxic Gas Monitor

SPM Flex

The 6500-LRK is long range of reflection kit for conventional and addressable Reflected Type Projected Beam Smoke Detector.

Detector removal tool

Rain protection cover for FSKB 2003

Fire Protection Housing

PAN series signalers have Polycarbonate film with the words "ALLARME GAS" for PAN1-EU, PAN1A-EU, PAN-1E and PAN-1AE models.

Housing for modules. surface mounting of up to 6 Modules M700 Series, consisting of housing back and cover.

Multi-Spectrum™ SS4 electro-optical fire detectors are fast reacting, digital, configurable, computerized “smart” units.

Sounder N120

B401 plug-in detector bases are used with System Sensor® conventional S300 smoke and heat detectors. These bases make detectors more versatile than equivalent direct-wired models.

B224BI Plug-in Isolator Detector Bases prevent an entire communications loop from being disabled when a short circuit occurs.

FAAST Automatic Purging Unit provides a fully integrated and compact solution with user-selectable preventative or event triggered purging programs.

Midas® Gas Detector

FS24X Flame Detector

M200 Addressable Modules Mounting Box with 20mm knockouts, consists of white plastic back and a black transparent cover.

Door Magnets are used as hold open devices for fire protection exclusions (fire protection swing doors, rolling gates, fire shutters with self-locking devices). They are available with distance pipe and without release button.

Adjustable mounting bracket

Valve regulated lead acid batteries are 12V batteries with 17Ah capacity.

The Yuasa NP series NP7-12 batteries utilize the latest advance design oxygen recombination technology. Yuasa has applied their 80 years of experience in the lead acid battery field. These are equipped with a simple, safe low pressure venting system.

M200-DIN is a Rail Bracket used with M700 series Module. The M700 Series module is designed for use protocol fire alarm control panel and include selectable loop isolation in every device.

Replacement HSS Sensor for NFXI-ASDxx-HS(-EB)

B501 bases are four-inch flangeless mounting bases designed for use with System Sensor® 200 Series detectors. They are intended for use with intelligent systems that have screw terminals for power (+ and -) and remote annunciator connections.

WB-1AP(-IV) plastic enclosure kit that minimizes the effect of condensation on the sensor. The enclosure is designed to accommodate 18.6mm conduit.

X-DA High Efficiency Power Amplifiers are the Class-D amplifiers and they are lighter, more stable, and high efficiency. The audio transmission is completely digitalized which makes it free from interference and easy to be controlled

Door Magnets are used as hold open devices for fire protection exclusions (fire protection swing doors, rolling gates, fire shutters with self-locking devices). They are available with distance pipe and without release button.

ECO1003 optical smoke sensors use state-of-the-art optical chambers combined with application-specific integrated circuits (ASIC) to provide quick and accurate detection of fires.

AirSCan IRF9 Sensor by Honeywell Analytics is a range of Infrared diffusion-based gas detection that enables thermal stability and freedom from vibration. The IRF9 satisfies AB32 California code and is CARB compliant.

The ECO1005 thermal detector belongs to System Sensor’s ECO1000 range of detectors. ECO1000 is a range of conventional detectors produce latest manufacturing technology and supplied with an array of advanced features, making them ‘better by design’.

ECO1000 conventional relay bases are for use with System Sensor® ECO1000 series sensor heads and are designed to operate in both 2- and 4-wire systems, with screw terminals provided for power connections and remote annunciator.

The ECO1002 multi-criteria detector uses a state-of-the-art optical chamber and a thermal element combined with a microprocessor, running sophisticated algorithms to provide quick and accurate detection of fires.

Yuasa’s NP series valve regulated lead acid batteries utilise the latest advance design Oxygen Recombination Technology. Due to the perfectly sealed construction and the recombination of gasses, it is almost maintenance free.

Activation Element

The valve regulated lead acid batteries by Yuasa are 12 volt 38Ah valve-regulated, maintenance free lead acid battery. Yuasa have applied their 80 years experience in the lead acid battery field to produce the optimum design of lead acid batteries.

The valve regulated lead acid batteries can be installed and operated in any orientation except permanently inverted.

The valve regulated lead acid batteries by Yuasa are 12 volt 24Ah valve-regulated, maintenance free lead acid battery. Yuasa have applied their 80 years experience in the lead acid battery field to produce the optimum design sealed batteries.

This three-day program addresses Workstation and NOTI-FIRE-NET configurations, Cooperative Control-By-Event (CCBE) programming and associated peripherals.

System Sensor’s ECO1000 range of detectors have been produced using the latest in manufacturing technology, supplied with an array of advanced feature.

Zone Expander RK-ZONE8

RK-MCU INTEVIO master control units are the central management device of the INTEVIO PA/VA system, which is used to manage and monitor all devices and perform various operations.

System Sensor Bases that are intended for use with ECO1000 Series detectors.

Power Amplifier RK-AMP500

Honeywell’s Touchpoint™ plus controllers bring a whole new control experience to your small system of gas detectors. Its modular approach enables you to take control and configure what you need for a wide range of applications.

RK-MIC remote call stations are used to perform various broadcasts and live announcement in zones.

This course will introduce you to the Inspire panel, the latest features and benefits, including any differences to other systems (for example, Onyx).

This virtual instructor led course covers the ONYX range of life safety products from Notifier. Providing the basic training needed to configure and program the system.