Fire Brigade Control Panel

Esser LCD Indicator Panel includes 10 Programming Interfaces, Internal Buzzer, Programmable Relay.

Wireless Control Centre is a software which control or monitor of single battery emergency and safety lights and can be implemented effortlessly. The subsequent configuration of radio system for monitoring and controlling safety lights is very easy.

Mains Switching Unit MSU

ONYXWorks IP Interface are IP gateway (NION), for connection ONYXWorks fire graphics systems to Notifier fire panel. Requires dc power and enclosure

Transmitting DAS Remote Controls They are allow remote control and the return of information related to the connected DAS.

The Vigilon A3 Mimic provides a pictorial representation of a building’s layout.

Delta OP + is a control panel developed for both centralized and decentralized operation of Eltek's fire alarm system. Delta OP + is used as a fire protection panel for larger fire alarm systems but also as a display unit located in the building.

Power Supply Base boards are designed as replacement for NFS panel range.

ATTP

Esser’s side panels without housing are equipped with 32 red or yellow indicators for signaling fire alarms. The 32nd LED is made in the colors yellow/green instead of yellow/red. It is intended for installation in a sprinkler control panel.

GMT 4000 Repeater Panel

Optional Cards are used to connect the LCD-8000-L displays on CAN Bus Network between Boxes.

Fire brigade information and operation system

Module with selectable interface RS422 or RS485 and has galvanic isolation.

ID3002 Fire Alarm Panels are enhanced two-loop intelligent fire alarm panel

Interface modules (RS232, RS485, TTY) for the fire brigade peripherals and the Serial essernet Interface.

Operating Fronts for IQ8Control are available with the respective country specification

FB Information and Operating System comes in sheet steel housing with two doors for surface mount or flush mount installation with central door opening for both door.

SMART3 Series Gas Accessories includes calibration keypad that connects to the detector for Zero, Span, calibration software for “SMART 3” sensors and plug-in identification card for "SMART 3" sensor programming.

SZI Front has 192 detector zone with 5mA.

Vigilon Plus Repeat control panel provides full display and control of the system.

Esser’s IQ8Control C/M operating unit fronts come with integrated Swiss fire department operating and indicating unit (FBOIU).

Gent Replacement Master Repeat Cards (MRC) are designed for installation into a new Repeat panel or A3 Mimic panel, that are wired on to a loop of an EN54 or BS5839 analogue and addressable fire detection and alarm systems.

N-15

WINMAG plus PC for SDI are preconfigured and are equipped with keyboard, mouse, screen and 2 ports.

The fire brigade control panel is an additional device for fire alarm systems with transmission devices to the fire brigade. The main display and control elements of the fire alarm control panel are on the fire brigade control panel

Eltek’s DELTA OP + control panels are panels developed for both centralized and decentralized operation of Eltek's fire alarm system. It is a microprocessor-based control panel. It represents the important nerve center in the fire alarm installation.

Outstation Push Door. For use as a Fire Telephone system, Disabled Refuge Call system or as a combined system when both Fire Telephones and Disabled Refuge Points are required.

58355

BAAS Sa Me (Type 2b)

Summary Report Table is used to report faults by indicator lights from an Autonomous Audible Alarm Unit (BAAS) type Pr.

BAAS SaMeFlash Satellite Sound Alarm Autonomous Unit ensure Sound signal broadcast, Broadcasting a pre-recorded message and a red light signal for the hearing impaired.

The Autonomous Audible Alarm Units (BAAS) of the Pr type are specially designed for the protection of people in establishments requiring a category C, D or E fire safety system

Autonomous Luminous Alarm Unit ensure the broadcast of a red light signal for the hearing impaired.

Autonomous Sound Alarm Units have been designed for broadcasting of sound signals or pre-recorded messages.

BAAS MaFlash Autonomous Sound Alarm Unit ensure the broadcasting of the sound signal and red light signal for the hearing impaired

The Autonomous Audible Alarm Units (BAAS) of the Pr type are specially designed for the protection of people in establishments requiring a category C, D or E fire safety system

Zone Expander RK-ZONE8

RK-MCU INTEVIO master control units are the central management device of the INTEVIO PA/VA system, which is used to manage and monitor all devices and perform various operations.

BAAS Ma Autonomous Sound Alarm Block ensure the broadcasting of the sound signal.

The Autonomous Audible Alarm Units (BAAS) of the Pr type are specially designed for the protection of people in establishments requiring a category C, D or E fire safety system

Type A Outstation has compact design and high volume ringer. It is available in red color and has magnetic push catch door for quick access.

Compact 5 Stainless Panel Cover

Type A Outstation Flush Surround- Stainless Steel

BAAS Sa satellite sound alarm autonomous units type Pr are specially designed for the protection of people in establishments requiring a category C, D or E fire safety system.

Digital Type A Outstation-Stainless Steel Surface Mount 

Network Slave Exchange Unit-Wall Mount (exc batteries 2x 12v 12Ah required)

Digital Type B Outstation-Stainless Steel Surface Mount (Q3 2019)

The DOM is the central control element of the VARIODYN® D1. The DOM4-8 and DOM4-24 modules are equipped with four independent audio outputs in order to access four channels.

Digital Integrated System Manager is highly integrated and easy-access pre-set buttons built-in fault diagnosis. It has automatic volume control and extendable zones connections via software configuration.

Indicator and Operating Module for displaying the current smoke density and the alarm level of the LRS 100 detector unit and the LRS compact/net.