Problem:

How do I install an A083 Ethernet module?
How to install an Ethernet module on a Flex panel?
 

Environment:

• Ethernet Module
• A083; A083-00-01; A083-00-02
• Galaxy Flex; Galaxy Flex 20; Galaxy Flex 50; Galaxy Flex 100
• FX20; FX50; FX100

Solution:

To install an A083 Ethernet module take the following steps:

1. Power down the system, mains first then the battery.  Note: the Galaxy Flex does have an auto detect mode (menu option 72) but Honeywell strongly recommends powering down the panel to avoid causing any potential problems with the module.
2. Remove the Ethernet module from its packaging
3. Fit the jumper on P3 
4. In the control panel enclosure fit the Ethernet module into the module rack nearest to the panel PCB
5. Disconnect the 15V power supply cable from the panel PCB
6. Connect the Intellibus cable from the panel connector PL3 to connector P2 on the Ethernet module
7. Connect the power cable from J4 on the Ethernet module to SK3 on the panel PCB
8. 8. Connect the Cat5 cable to the Ethernet connector J3
9. Connect the 15V power supply cable to J5 on the Ethernet module
10. Repower the system, mains first followed by the battery
11. Check of the system has seen the new module in menu option 61.6 (COMM Modules)